Headphone maintenance

maintainance:

After a headset is in hand, we must first praise the headset. I believe everyone will know the reason for this. After the testimonial is opened, we can enjoy it, but as long as the testimonial is opened, everything will be fine? The answer is no, the quality of some earphones itself is very good. It is because we usually use carelessly that we make our beloved earphones premature Died! Here are some common situations in the process of repairing headphones, and I will give you some maintenance suggestions!

1. It is best not to wear headphones while sleeping. It is absolutely impossible for ordinary people to stay still overnight. After a long time, the headphone cord is either wrapped around the neck or the two cords are twisted together like twists. Some large headphones are even crushed. The 100 and 200 beams are also relatively fragile at the beginning! If some friends say that I can’t sleep if I don’t listen to songs, then it’s best to hang the earphones above your head with a rubber band tied to the earphone cable on the head of the bed. The headset will be "pulled" when you tilt your head when you fall asleep, no matter how you turn over, you won't be pressed! The advantage of using rubber bands is that it acts as a buffer when pulling the earphones!

2. After using the earphones, wipe off the sweat on the earphone cable. These things secreted by the human body, containing grease or something, are the invisible killer of the wire, such as e2c at the bend of the ear. Over time, the wire will age, which will eventually lead to seams and breaks.

3. It is best not to smoke when using headphones. When everyone is not careful, whether it is the earphone shell or the earphone cable is hot, can you not feel bad for hundreds of thousands of oceans? ? ? In addition, soot will enter the earphone shell and stick to the diaphragm, and the sound will be wrong after a long time.

4. Be sure to turn down the volume before use. If the volume of your output device is too loud, it will not only shock your ears, but also shock the membrane folds. The worst one burns the voice coil of the headset.

5. Keep the earphones away from strong magnets. The magnetism of the unit will decrease, and the sensitivity will decrease over time!

6. Keep the earphones away from moisture. The pads in the headphone unit will be rusty, the resistance will increase, and your headphones will be biased.

7. Plug part. Some friends like to put mp3 or something in their trouser pockets, the outlet part of the plug is easy to fold, and it will be disconnected after a long time.

8. Do not disassemble. The curiosity is too strong, just open it and take a look. Some earphones are difficult to disassemble, mx500 cannot be disassembled without special methods, even if you disassemble 80% of them, it will be broken. If the small 2 is opened, the shell may be damaged, or there may be a partial tone, such as 888 and 808 are okay, it is easier to handle.

9. It is best not to use it outside in winter. In the cold winter, the wire is hard and brittle, and excessive bending can easily break the wire. Do not heat the headphone cable at this time, as the high temperature will accelerate the aging of the cable.

10. Keep away from chemicals. The paint on the earphone shell is very soluble in organic chemicals.

• Previous：Basic FAQ of Headphones
• Next：Data updata!